May be it's Spiral vs Zig-Zag option?narvf писал(а):In tecroids image for exmaple path goes down, right, up, right, down, right and so on except for letters so on.
area doesn't fill correctly
- Nick
- Мастер
- Сообщения: 22776
- Зарегистрирован: 23 ноя 2009, 16:45
- Репутация: 1735
- Заслуга: Developer
- Откуда: Gatchina, Saint-Petersburg distr., Russia
- Контактная информация:
Re: area doesn't fill correctly
-
- Новичок
- Сообщения: 25
- Зарегистрирован: 18 июн 2014, 13:35
- Репутация: 1
- Контактная информация:
Re: area doesn't fill correctly
hi,
i just played around a bit and i think i've found some good working configuration.
However, I've got some questions.
Is it possible to set the zig zag orientation? sometimes it would be easier if it was the other way..
Next, I find it a bit disturbing that my mill pre penetrates any corner of the zig zag about five times before it mills.. can i reduce that number?
i just played around a bit and i think i've found some good working configuration.
However, I've got some questions.
Is it possible to set the zig zag orientation? sometimes it would be easier if it was the other way..
Next, I find it a bit disturbing that my mill pre penetrates any corner of the zig zag about five times before it mills.. can i reduce that number?
- Nick
- Мастер
- Сообщения: 22776
- Зарегистрирован: 23 ноя 2009, 16:45
- Репутация: 1735
- Заслуга: Developer
- Откуда: Gatchina, Saint-Petersburg distr., Russia
- Контактная информация:
Re: area doesn't fill correctly
There should be angle parameter which defines zig-zag "orientation"tecdroid писал(а):Is it possible to set the zig zag orientation? sometimes it would be easier if it was the other way..
What does that mean?tecdroid писал(а): I find it a bit disturbing that my mill pre penetrates any corner of the zig zag about five times before it mills.. can i reduce that number?
-
- Новичок
- Сообщения: 25
- Зарегистрирован: 18 июн 2014, 13:35
- Репутация: 1
- Контактная информация:
Re: area doesn't fill correctly
When engraving an area the machine runs a straight line, goes up to safe z, goes down, runs next line and so on..
i'd like it to engrave the whole area and only going to safe position when neccessary..
i'd like it to engrave the whole area and only going to safe position when neccessary..
-
- Кандидат
- Сообщения: 60
- Зарегистрирован: 22 июл 2014, 11:39
- Репутация: 4
- Контактная информация:
Re: area doesn't fill correctly
I think it's actually not possible :/
-
- Новичок
- Сообщения: 25
- Зарегистрирован: 18 июн 2014, 13:35
- Репутация: 1
- Контактная информация:
Re: area doesn't fill correctly
well, should be since it saves much time..