area doesn't fill correctly

cnc-club.ru for English speaking users
Аватара пользователя
Nick
Мастер
Сообщения: 22776
Зарегистрирован: 23 ноя 2009, 16:45
Репутация: 1735
Заслуга: Developer
Откуда: Gatchina, Saint-Petersburg distr., Russia
Контактная информация:

Re: area doesn't fill correctly

Сообщение Nick »

narvf писал(а):In tecroids image for exmaple path goes down, right, up, right, down, right and so on except for letters so on.
May be it's Spiral vs Zig-Zag option?
tecdroid
Новичок
Сообщения: 25
Зарегистрирован: 18 июн 2014, 13:35
Репутация: 1
Контактная информация:

Re: area doesn't fill correctly

Сообщение tecdroid »

hi,
i just played around a bit and i think i've found some good working configuration.
However, I've got some questions.
Is it possible to set the zig zag orientation? sometimes it would be easier if it was the other way..
Next, I find it a bit disturbing that my mill pre penetrates any corner of the zig zag about five times before it mills.. can i reduce that number?
Аватара пользователя
Nick
Мастер
Сообщения: 22776
Зарегистрирован: 23 ноя 2009, 16:45
Репутация: 1735
Заслуга: Developer
Откуда: Gatchina, Saint-Petersburg distr., Russia
Контактная информация:

Re: area doesn't fill correctly

Сообщение Nick »

tecdroid писал(а):Is it possible to set the zig zag orientation? sometimes it would be easier if it was the other way..
There should be angle parameter which defines zig-zag "orientation"
tecdroid писал(а): I find it a bit disturbing that my mill pre penetrates any corner of the zig zag about five times before it mills.. can i reduce that number?
What does that mean?
tecdroid
Новичок
Сообщения: 25
Зарегистрирован: 18 июн 2014, 13:35
Репутация: 1
Контактная информация:

Re: area doesn't fill correctly

Сообщение tecdroid »

When engraving an area the machine runs a straight line, goes up to safe z, goes down, runs next line and so on..
i'd like it to engrave the whole area and only going to safe position when neccessary..
narvf
Кандидат
Сообщения: 60
Зарегистрирован: 22 июл 2014, 11:39
Репутация: 4
Контактная информация:

Re: area doesn't fill correctly

Сообщение narvf »

I think it's actually not possible :/
tecdroid
Новичок
Сообщения: 25
Зарегистрирован: 18 июн 2014, 13:35
Репутация: 1
Контактная информация:

Re: area doesn't fill correctly

Сообщение tecdroid »

well, should be since it saves much time..
Ответить

Вернуться в «English forum»