Hi!
I've seen that there are some pluto-p users.
I've found some race condition bugs in pluto-p drivers (in verilog code).
Currently the changes are only for the pluto-servo code due to the lack of stepper equipment (its on the way).
https://github.com/tinkercnc/linuxcnc-m ... o_firmware
https://github.com/tinkercnc/linuxcnc-m ... 014bcd3cb4
Copying the pluto_servo.rbf in an existing src tree and compiling lasts out because the changes in the driver dir are not necessary.
The stepper fix will be given later.
---------
Matsche
Pluto-P
-
- Мастер
- Сообщения: 953
- Зарегистрирован: 23 фев 2011, 01:50
- Репутация: 36
- Контактная информация:
Re: Pluto-P
Could you show where were errors please.mimi писал(а):I've found some race condition bugs in pluto-p drivers (in verilog code).